Measuring for alignment of tiles such as wall coverings. Should be below scrap or coverings not the full height of the wall, Should be full tiles to on top. Tile flooring, Should define with scrap on the left side.

Adjust the floor or wall to achieve the desired level, Use a trowel cement plaster sand mix or cement glue screw the wall to install. Bring the desired tile, Soak the water before leaving for about 20-30 minutes to make the tile absorb water until saturated, Then bring the tile to make dry with wind.

Ligament stretch control horizontal and vertical. Tiled from the middle of the lathe. Use a trowel to scoop plaster put on the back of the tile, Plaster as groove all over the tile bring tiles on the floor along the line. Then knock gently with a rubber hammer or trowel handle, Stick with surface.

Should be tiled space refrain groove 0.3-1.0 cm.  and set tiles give the color weights light-mid-deep spread over the area. Between tiled should be using sponge wipe stain the plaster while the mortar is still wet.

Tiled Not full sheet, Measure the part you want to cut out with the tape measure. Tick mark, Before cutting with tile cutter.

When the tiled is finished, Leave at least 12 hours. Then the grout with white cement or color cement adhesives mixed with fine sandpat along the grout of the tile. Leave it damp and then use a clean sponge wipe excess plaster.

- Purpose of use. Should be choose to suit the use.

- Ceramic tiles or high temperature ceramic tiles, Use the temperature to burn at 1,250  ํC - 1,300  ํC.  Make tiles have a strong resistant to scratches and chemicals.

- Considered from raw materials. Must be produced from quality clay and mineral, No harm to manufacturers, users and the environment.

- Soil and coating as homogeneous because pass burn to until cooked. The tiles must not be cracked, not chipped or bent.

- color of tiles. Should be have Identity of handmade for example There are color shades make feel the natural.